- FTDI USB CHIP FOR MAC SERIAL
- FTDI USB CHIP FOR MAC DRIVERS
- FTDI USB CHIP FOR MAC FULL
UHCI/OHCI/EHCI host controller compatible.#.Supports self powered, bus powered and high-power bus powered USB configurations.Configurable I/O drives strength (4, 8, 12 or 16mA) and slew rate.Operation configuration mode and USB Description strings configurable in external EEPROM over the USB interface.
FTDI USB CHIP FOR MAC SERIAL
Auto-transmit enable control for RS485 serial applications using TXDEN pin. UART Interface supports 7/8 bit data, 1/2 stop bits, and Odd/Even/Mark/Space/No Parity. Fully assisted hardware or X-On / X-Off software handshaking. FTDI USB CHIP FOR MAC FULL
Asynchronous serial UART interface option with full hardware handshaking and modem interface signals.Highly integrated design includes 5V to 3.3/+1.8V LDO regulator for VCORE, integrated POR function.Bit-bang Mode interface option with RD# and WR strobes.Option for transmit and receive LED drive signals.
FTDI USB CHIP FOR MAC DRIVERS
FTDI’s royalty-free Virtual Com Port (VCP) and Direct (D2XX) drivers eliminate the requirement for USB driver development in most cases.
CPU-style FIFO interface mode simplifies CPU interface design. Supports a half duplex FT1248 interface with a configurable width, bi-directional data bus (1, 2, 4 or 8 bits wide). USB to synchronous 245 parallel FIFO mode for transfers up to 40 Mbytes/Sec. USB to asynchronous 245 FIFO mode for transfer data rate up to 8 MByte/Sec. (RS232 Data Rate limited by external level shifter). UART transfer data rate up to 12Mbaud. Multi-Protocol Synchronous Serial Engine (MPSSE) to simplify synchronous serial protocol (USB to JTAG, I2C, SPI or bit-bang) design. USB 2.0 Hi-Speed (480Mbits/Second) and Full Speed (12Mbits/Second) compatible. No USB specific firmware programming required. Entire USB protocol handled on the chip. Single channel USB to serial / parallel ports with a variety of configurations. This 48 pin device is available in either LQFP or QFN packaging, and is ROHS compliant. FTDI provides royalty-free virtual com port and D2XX drivers for Microsoft Windows (XP – Windows7), Apple Mac OSX, and Linux. On-board voltage regulation provides 3.3V and 1.8V supplies from a 5V source, as well as a power-on-reset function. The I/O structure is 3.3V with built-in tolerance for 5V, allowing the designer maximum flexibility when interfacing with FPGAs. In addition, this device features the new synchronous, half-duplex FT1248 bus, which allows an engineer to trade off bandwidth for pin count using 1, 2, 4, or 8 data lines at up to 30Mbytes/s. Using a serial EEPROM interface, this device can be configured for a wide variety of asynchronous and synchronous serial standards, such as JTAG, SPI, I2C and UART as well as synchronous and asynchronous parallel FIFO interfaces. Operating at USB Hi-Speed 480Mbps rate, this fast single channel bridge chip features either a flexible serial interface or parallel FIFO interface, with data transfer speeds up to 40Mbytes/s. With added Power Delivery(PD) functionality to the existing High Speed Series. USB High Speed Power Delivery Series are now available here. FT232H – Hi-Speed Single Channel USB UART/FIFO IC
0 kommentar(er)
